Ceia THS/MS21 - Maintenance Warnings

1
FI002K0018v1100UK – THS/21 Instruction manual for installation, use and maintenance
SAFETY INSTRUCTIONS -
W
ARNINGS
14 ORIGINAL INSTRUCTIONS
1.2.4 Maintenance warnings
- During all maintenance operations ensure the complete absence of any potentially explosive
atmosphere.
- Perform all maintenance operations following the procedures described in the
Maintenance
section of this manual.
- Before you move the machine or start maintenance or cleaning, switch off and lock out the
power supply and the compressed air supply.
- Before performing any maintenance or cleaning operation or moving the equipment, switch
the electrical and pneumatic disconnectors to the OFF position, fitting a padlock. See the
Installation section for the procedure.
- All the system containers have a protection class that protects them from dust and water
penetrating inside them. Do not open doors if there is dust or water in the atmosphere, to
prevent them getting in.
- Ensure that replacement fuses are of the correct rating and of the prescribed type. Makeshift
fuses and short-circuiting of the fuse boards are strictly forbidden.
- Clean the various parts of the system following the procedures defined by the customer.
Cleaning procedures should also comply with the hygiene requirements for the process and
the working environment and must also take into account the degree of protection of the
equipment.
- The machines are designed for use with a large range of food products and in a wide variety
of production environments. This makes it difficult for us to specify a sanitizing procedure for
all applications. It is the final user’s responsibility to draft suitable sanitizing procedures for
their applications.
The final user should also ensure that the instructions do not involve the use of methods or
substances which are incompatible with the machine characteristics specified in the manual.
- Read the chapter on
Maintenance
carefully before calling the service centre.
Whatever the problem, only specialized service personnel authorized to work with CEIA
equipment should be called.
- Any damaged parts of the device should be substituted with original components only.
- Any maintenance or repair of the device while open and powered up should be avoided and
in any case should only be carried out by trained personnel who are fully aware of the risks
which the operation entails, following the instructions given in the
Maintenance
section.
- Before you restart the machine, check that all the guards are present and efficient. Check
that the drive components and the electrical and pneumatic systems are efficient.
- Disposal of parts with environmental impact: follow the regulations in force in the country
where the device is being used (refer to the
Maintenance
section).