3
FI002K0018v1100UK – THS/21 Instruction manual for installation, use and maintenance
INSTALLATION
48 ORIGINAL INSTRUCTIONS
3.1.2 General installation guidelines for non-integrated models
Some THS models are designed for installation on conveyor belts or production lines provided and
set up by the customer. When designing these systems customers are advised to follow the
guidelines given in this manual to ensure that they get top performance from their CEIA Metal
Detectors.
The following notes provide additional instructions necessary for installing the detector on a conveyor belt or other
transport system set up by the customer.
For the installation checks you need to be able to switch on the system, understand the signals
given during use and set the applicable operating parameters. These operations are described in
the first part of section 4 – Use of the device.
3.1.2.1 Controls and Power Supply box
Standard EN 60204-1 specifies that the main switch and the other controls to be used by the
operator must be at a height of between 60 and 180 cm from the floor.
In cases where it is not possible to comply with this specification, you must install an additional
remote control unit (RCU) at the height specified.
To Next Page
Loading...
