5
FI002K0018v1100UK – THS/21 Instruction manual for installation, use and maintenance
MAINTENANCE
150 ORIGINAL INSTRUCTIONS
5.5 Compatibility check procedures
5.5.1 General compatibility check
This command performs a complete set of automatic checks to verify the environmental
compatibility of the Metal Detector (for electrical and/or mechanical noises) with the system where
it is installed and with the environment, in normal operating conditions and without product in
transit.
- Access the programming phase on
Configuration > Compatibility chk >
Gener.comp.check
menu and press the E key to start the procedure. The Metal Detector
will ask to stop or to restart the machines in question to move the product into the line, or
working in the Metal Detector nearby, following the sequence described below.
Step 1 Step 2 Step 3 Step 4
Transport stopped Transport stopped Transport running Transport running
During the procedure the execution of more steps may be requested.
- At the end of the procedure the Metal Detector indicates the estimated degree of
environmental compatibility:
INSUFFICIENT
/
SUFFICIENT
/
GOOD
. This result takes into
account the actual Metal Detector settings; however, its correct functionality needs to be
verified, including with product in transit.
5.5.2 Electrical Compatibility check
This command performs a complete set of automatic checks to verify the environmental
compatibility of the Metal Detector (for electrical noises only) with the system where it is installed
and with the environment, in normal operating conditions and without product in transit.
- Access the programming phase on
Configuration > Compatibility chk >
Gener.comp.check
menu and press the E key to start the procedure. The Metal Detector
will ask to stop or to restart the machines in question to move the product into the line, or
working in the Metal Detector nearby, following the sequence described below.
Step 1 Step 2
Transport stopped Transport running
During the procedure the execution of more steps may be requested.
- At the end of the procedure the Metal Detector indicates the estimated degree of
environmental compatibility:
INSUFFICIENT
/
SUFFICIENT
/
GOOD
. This result takes into
account the actual Metal Detector settings; however, its correct functionality needs to be
verified, including with product in transit.
To Next Page
Loading...
