Ceia THS/MS21 - Uninstallation Procedure; Disassembly; Packing; Probes

5
FI002K0018v1100UK – THS/21 Instruction manual for installation, use and maintenance
MAINTENANCE
158 ORIGINAL INSTRUCTIONS
5.7 Uninstallation procedure
5.7.1 Disassembly
Disconnect any power source from the device, before performing any operation.
Uninstall the probe and the Control Power Box from the production line and place them apart.
5.7.2 Packing
5.7.2.1 Probes
Place the probe on the wooden
base.
Place the manuals inside the tunnel and
fix the probe to the wooden base with
the plastic straps as shown in the figure.
Remember to protect the probe surface,
on top, with card strips.
Position the Power Supply Box
on top of the probe, placing the
cable around the base.
Refit the package to the wooden
base.
Fill the empty space around and on top
of the Power Supply Box and close the
package.
Close the package with plastic
straps.