Contents
15
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL-30933-01
Verifying OSPF NSF 12-13
Configuring IS-IS NSF 12-13
Verifying IS-IS NSF 12-14
Configuring EIGRP NSF 12-16
Verifying EIGRP NSF 12-16
Cisco High Availability Features in Cisco IOS XE 3.1.0SG 12-17
Environmental Monitoring and Power Management 13-1
About Environmental Monitoring 13-1
Using CLI Commands to Monitor your Environment 13-2
Displaying Environment Conditions 13-2
Displaying On Board Failure Logging (OBFL) information for 9000W AC 13-4
Emergency Actions 13-5
System Alarms 13-6
Power Management 13-7
Power Management for the Catalyst 4500 Series Switches 13-7
Supported Power Supplies 13-8
Power Management Modes for the Catalyst 4500 Switch 13-9
Selecting a Power Management Mode 13-10
Power Management Limitations in Catalyst 4500 Series Switches 13-10
Available Power for Catalyst 4500 Series Switches Power Supplies 13-14
Special Considerations for the 4200 W AC and 6000 W AC Power Supplies 13-15
Combined Mode Power Resiliency 13-19
Special Considerations for the 1400 W DC Power Supply 13-21
Special Considerations for the 1400 W DC SP Triple Input Power Supply 13-22
Powering Down a Module 13-22
Power Management for the Catalyst 4948 Switches 13-23
Power Management Modes for the Catalyst 4948 Switch 13-23
IEEE 802.3az Energy Efficient Ethernet 13-23
Determining EEE Capability 13-24
Enabling EEE 13-24
Determining EEE Status 13-24
Configuring Power over Ethernet 14-1
About Power over Ethernet 14-1
Hardware Requirements 14-2
Power Management Modes 14-2
Intelligent Power Management 14-4
Configuring Power Consumption for Powered Devices on an Interface 14-5
Displaying the Operational Status for an Interface 14-6
To Next Page
Loading...
