Contents
16
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL-30933-01
Displaying all PoE Detection and Removal Events 14-7
Displaying the PoE Consumed by a Module 14-8
PoE Policing and Monitoring 14-12
PoE Policing Modes 14-12
Configuring Power Policing on an Interface 14-13
Displaying Power Policing on an Interface 14-14
Configuring Errdisable Recovery 14-14
Enhanced Power PoE Support on the E-Series Chassis 14-15
Configuring Universal PoE 14-16
Configuring the Catalyst 4500 Series Switch with Cisco Network Assistant 15-1
About Network Assistant 15-2
Community Overview 15-2
Clustering Overview 15-2
Network Assistant-Related Parameters and Their Defaults 15-3
Network Assistant CLI Commands 15-3
Configuring Your Switch for Network Assistant 15-4
(Minimum) Required Configuration 15-4
(Additional) Configuration Required to Use Community 15-5
(Additional) Configuration Required to Use Clustering 15-5
Managing a Network Using Community 15-6
Candidate and Member Requirements 15-7
Automatic Discovery of Candidates and Members 15-7
Community Names 15-8
Hostnames 15-8
Passwords 15-8
Communication Protocols 15-8
Access Modes in Network Assistant 15-9
Community Information 15-9
Adding Devices 15-9
Converting a Cluster into a Community 15-10
Managing a Network Using Cluster 15-11
Understanding Switch Clusters 15-11
Cluster Command Switch Requirements 15-11
Network Assistant and VTY 15-12
Candidate Switch and Cluster Member Switch Requirements 15-12
Using the CLI to Manage Switch Clusters 15-13
Configuring Network Assistant in Community or Cluster Mode 15-13
Configuring Network Assistant on a Networked Switch in Community Mode 15-13
To Next Page
Loading...
