Cisco Catalyst 4500 Series - Page 1782

Index
IN-12
Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide
OL_28731-01
environmental monitoring
using CLI commands
13-1
EPM logging 45-129
errdisable recovery
configuring
14-14
EtherChannel
channel-group group command
5-46, 25-8, 25-10
configuration guidelines 5-30, 25-5
configuring 25-6 to 25-16
configuring (tasks) 5-30
configuring Layer 2 25-10
configuring Layer 3 25-7
DFC restriction, see CSCdt27074 in the Release Notes
displaying to a virtual switch system
25-16
interface port-channel command 25-7
lacp system-priority
command example
25-13
modes 25-3
overview 25-2
PAgP
Understanding
25-4
physical interface configuration 5-46, 25-7
port-channel interfaces 25-2
port-channel load-balance command 25-14
removing 25-15
removing interfaces 25-15
understanding 5-2
EtherChannel guard
disabling
24-6
enabling 24-6
overview 24-6
Ethernet management port
and routing
8-6
and routing protocols 8-6
configuring 8-10
default setting 8-6
described 1-29, 8-6
for network management 1-29, 8-6
specifying 8-10
supported features 8-10
unsupported features 8-10
Ethernet management port, internal
and routing protocols
8-6
Ethernet Management Port, using 8-6
Ethernet OAM 64-34
and CFM interaction 64-51
configuration guidelines 64-35
configuring with CFM 64-51
default configuration 64-35
discovery 64-34
enabling 64-36, 64-52
link monitoring 64-34, 64-38
messages 64-34
protocol
defined
64-33
monitoring 64-49
remote failure indications 64-34
remote loopback 64-34, 64-37
templates 64-45
Ethernet OAM protocol CFM notifications 64-51
Ethernet Remote Defect Indication (ETH-RDI) 64-28
event triggers, user-defined
configuring, 802.1X-based
20-8
configuring, MAC address-based 20-9
explicit host tracking
enabling
26-11
extended range VLANs
See VLANs
Extensible Authentication Protocol over LAN
45-2
Exterior Gateway Protocol
See EGP
F
Fa0 port
See Ethernet management port
Failure detection, using BFD
38-7
Fallback Authentication