Cisco Catalyst 4500 Series - Page 1783

Index
IN-13
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
configure with 802.1X 45-77
FastDrop
overview
36-11
fastethernet0 port
See Ethernet management port
Fast-Hello
dual-active detection
5-24
Fast-Hello dual-active detection, configuring 5-50
fast link notification
on VSL failure
5-14
Fast UDLD
configuring probe message interval
31-8
default configuration 31-4
displaying link status 31-9
enabling globally 31-5
enabling on individual interface 31-7
enabling per-interface 31-6
modes of operation 31-3
resetting disabled LAN interfaces 31-8
use case 31-2
Fast UDLD, overview 31-1
feature interactions, Wireshark 57-10
FIB
description
34-2
See also MFIB
fiber-optics interfaces
disabling UDLD
31-7
Filter-ID ACL and Per-User ACL, configureport-based
authentication
configure Per-User ACL and Filter-ID ACL
45-45
filtering
in a VLAN
52-18
non-IP traffic 52-14, 52-15
filters, Wireshark 57-6
flags 36-12
Flash memory
configuring router to boot from
3-31
loading system images from 3-30
security precautions 3-31
Flexible NetFlow
caveats
63-1, 63-7
defined 1-4, 63-1
Flex Links
configuration guidelines
22-6
configuring 22-6, 22-7
configuring preferred VLAN 22-9
configuring VLAN load balancing 22-8
monitoring 22-12
flooded traffic, blocking 54-2
flowchart, traffic marking procedure 41-21, 41-55
flow control, configuring 8-23
For 14-13
forward-delay time (STP)
configuring
21-19
forwarding information base
See FIB
frame command
72-5
G
gateway
See default gateway
get-bulk-request operation
61-3
get-next-request operation 61-3, 61-4
get-request operation 61-3, 61-4
get-response operation 61-3
Gigabit Ethernet SFP ports
deploy with 10-Gigabit Ethernet
8-12, 8-13
GLBP, introduction 1-15
global configuration mode 2-5
Guest-VLANs
configure with 802.1X
45-57
H
hardware and software ACL support 52-6
hardware switching 34-5