Index
IN-15
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
enabling
globally
26-6
on a VLAN 26-6
enabling and disabling 27-6
IP multicast and 36-4
monitoring 26-14, 27-10
overview 26-2
IGMP Snooping, displaying
group
26-16
hot membership 26-15
how to 26-15
MAC address entries 26-18
multicast router interfaces 26-17
on a VLAN interface 26-18
Querier information 26-19
IGMPSnooping Querier, configuring 26-10
Immediate Leave, IGMP
enabling
27-8
immediate-leave processing
enabling
26-8
IGMP
See fast-leave processing
ingress packets, SPAN enhancement
56-12
inline power
configuring on Cisco IP phones
42-5
insufficient inline power handling for Supervisor Engine
II-TS
13-22
Intelligent Power Management 14-4
interacting with Baby Giants 8-29
interface
displaying operational status
14-6
interface command 3-9, 8-2
interface configuration
REP
23-10
interface link and trunk status events
configuring
8-37
interface port-channel command 5-45, 25-7
interface range command 8-4
interface range macro command 8-11
interfaces
adding descriptive name
8-23
clearing counters 8-36
configuring 8-2
configuring ranges 8-4
displaying information about 8-36
Layer 2 modes 18-3
maintaining 8-35
monitoring 8-35
naming 8-23
numbers 8-2
overview 8-2
restarting 8-37
See also Layer 2 interfaces
using the Ethernet Management Port
8-6
Internet Control Message Protocol
See ICMP
Internet Group Management Protocol
See IGMP
Internet Protocol version 6
See IPv6
introduction
802.1X Identity-Based Network Security, list of
supported features
1-34
Bidirectional Forwarding Detection 1-14
Cisco Call Home 1-24
Cisco Energy Wise 1-24
Cisco Express Forwarding 1-14
Cisco IOS IP Service Level Agreements 1-24
Cisco IOS Mediatrace and Performance Monitor 1-26
Cisco Medianet AutoQoS 1-25
Cisco Medianet Flow Metadata 1-26
Cisco Media Services Proxy 1-25
Cisco TrustSec MACsec Encryption 1-35
Cisco TrustSec Security Architecture 1-36
Debugging Features (platform and debug
platform)
1-43
Device Sensor 1-14
Dynamic Host Control Protocol 1-28