Index
IN-19
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
L
l2protocol-tunnel command 28-17
labels, definition 41-3
LACP
system ID
25-4
Layer 2 access ports 18-7
Layer 2 Control Packet QoS
and CoPP configuration example
49-14
default configuation 49-11
disabling 49-13
enabvling 49-12
guideline and restrictions 49-16
understanding 49-11
Layer 2 frames
classification with CoS
41-2
Layer 2 interface
applying ACLs
52-31
configuring access-mode mode on 52-31
configuring IPv4, IPv6, and MAC ACLs 52-29
displaying an ACL configuration 52-32
Layer 2 interfaces
assigning VLANs
16-7
configuring 18-5
configuring as PVLAN host ports 43-18
configuring as PVLAN promiscuous ports 43-17
configuring as PVLAN trunk ports 43-19
defaults 18-4
disabling configuration 18-8
modes 18-3
show interfaces command 18-6
Layer 2 interface type
resetting
43-24
setting 43-24
Layer 2 protocol tunneling
default configuration
28-16
guidelines 28-16
Layer 2 switching
overview
18-1
Layer 2 Traceroute
and ARP
9-10
and CDP 9-10
host-to-host paths 9-10
IP addresses and subnets 9-10
MAC addresses and VLANs 9-10
multicast traffic 9-10
multiple devices on a port 9-10
unicast traffic 1-42, 9-9
usage guidelines 9-10
Layer 2 trunks
configuring
18-5
overview 18-3
Layer 3 interface, applying IPv6 ACLs 52-17
Layer 3 interface counters,configuring 33-10
Layer 3 interface counters,understanding 33-3
Layer 3 interfaces
changing from Layer 2 mode
40-16
configuration guidelines 33-5
configuring VLANs as interfaces 33-7
overview 33-1
counters 33-3
logical 33-2
physical 33-2
SVI autostate exclude 33-3
Layer 3 packets
classification methods
41-2
Layer 4 port operations
configuration guidelines
52-11
restrictions 52-10
Leave timer, enabling 26-9
licenses, managing with PRTU 4-14
limitations on using a TwinGig Convertor 8-14
Link Aggregation Control Protocol, introduction 1-7
link and trunk status events
configuring interface
8-37
link integrity, verifying with REP 23-4
Link Layer Discovery Protocol
See CDP
To Next Page
Loading...
