Cisco Catalyst 4500 Series - Page 1790

Index
IN-20
Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide
OL_28731-01
link monitoring, Ethernet OAM 64-34, 64-38
link-state tracking
configuration guidelines
25-21
default configuration 25-21
described 25-18
displaying status 25-22
generic configuration procedure 25-21
link status, displaying UDLD 31-9
listening state (STP)
RSTP comparisons (table)
21-24
LLDP
configuring
30-4
characteristics 30-5
default configuration 30-5
disabling and enabling
globally
30-6
on an interface 30-7
monitoring and maintaining 30-14
overview 30-1
transmission timer and holdtime, setting 30-5
LLDP-MED
configuring
procedures
30-4
TLVs 30-9, 30-11
monitoring and maintaining 30-14
overview 30-1
supported TLVs 30-2
LLDP Media Endpoint Discovery
See LLDP-MED
load balancing
configuring for CEF
34-7
configuring for EtherChannel 25-14
overview 25-5, 34-6
per-destination 34-7
load splitting IP multicast traffic 36-22
Location Service
overview
30-1
location service
configuring
30-12
understanding 30-3
location TLV 30-3, 30-9
logging, EPM 45-129
Logical Layer 3 interfaces
configuring
33-6
logical layer 3 VLAN interfaces 33-2
login authentication
with RADIUS
45-106
with TACACS+ 3-19
login banners 4-24
login timer
changing
9-6
logoutwarning command 9-6
loop guard
and MST
21-23
configuring 24-4
overview 24-3
M
MAC/PHY configuration status TLV 30-2
MAC addresses
aging time
4-30
allocating 21-6
and VLAN association 4-29
building tables 4-28, 18-2
convert dynamic to sticky secure 48-5
default configuration 4-30
disabling learning on a VLAN 4-39
discovering 4-44
displaying 9-3
displaying in DHCP snooping binding table 51-19
dynamic
learning
4-29
removing 4-31
in ACLs 52-14
static
adding
4-37
allowing 4-38