Cisco Catalyst 4500 Series - Page 1801

Index
IN-31
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
displaying the configuration 45-116
identifying the server 45-103
limiting the services to the user 45-110
method list, defined 45-103
operation of 45-97
server load balancing 45-116
suggested network environments 45-96
tracking services accessed by user 45-111
understanding 45-96
RADIUS, controlling switch access with 45-95
RADIUS Change of Authorization 45-97
RADIUS server
configure to-Switch communication
45-32
configuring settings 45-34
parameters on the switch 45-32
RA Guard
configuring
52-36
deployment 52-36
examples 52-37
introduction 52-35
usage guidelines 52-38
range command 8-4
range macros
defining
8-11
ranges of interfaces
configuring
8-4
Rapid Spanning Tree
See RSTP
rcommand command
15-13
reachability, tracking IP SLAs IP host 58-9
re-authentication of a client
configuring manual
45-94
enabling periodic 45-81
redirect URLs, port-based authentication 45-20
reduced MAC address 21-2
redundancy
configuring
10-7, 11-7
guidelines and restrictions 10-5, 11-5
changes made through SNMP 10-11, 11-11
NSF-aware support 12-2
NSF-capable support 12-2
overview 10-2, 11-2
redundancy command 10-8, 11-7
understanding synchronization 10-4, 11-5
redundancy (NSF) 12-1
configuring
BGP
12-11
CEF 12-10
EIGRP 12-16
IS-IS 12-13
OSPF 12-12
routing protocols 12-5
redundancy (RPR)
route processor redundancy
10-2, 11-3
synchronization 10-5, 11-5
redundancy (SSO)
redundancy command
12-10
route processor redundancy 10-3, 11-3
synchronization 10-5, 11-5
reload command 3-28, 3-29
Remote Authentication Dial-In User Service
See RADIUS
remote failure indications
64-34
remote loopback, Ethernet OAM 64-34, 64-37
Remote Network Monitoring
See RMON
rendezvous point, configuring
36-17
rendezvous point, configuring single static 36-20
REP
administrative VLAN
23-8
administrative VLAN, configuring 23-9
and STP 23-6
configuration guidelines 23-7
configuring interfaces 23-10
convergence 23-4
default configuration 23-7
manual preemption, configuring 23-13
monitoring 23-14