Cisco Catalyst 4500 Series - Page 1802

Index
IN-32
Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide
OL_28731-01
neighbor offset numbers 23-5
open segment 23-2
ports 23-6
preempt delay time 23-5
primary edge port 23-4
ring segment 23-2
secondary edge port 23-4
segments 23-1
characteristics 23-2
SNMP traps, configuring 23-14
supported interfaces 23-1
triggering VLAN load balancing 23-6
verifying link integrity 23-4
VLAN blocking 23-13
VLAN load balancing 23-4
replication
description
36-9
report suppression, IGMP
disabling
27-10
reserved-range VLANs
See VLANs
reset command
72-3
resetting an interface to default configuration 8-40
resetting a switch to defaults 3-32
Resilient Ethernet ProtocolLSee REP
responder, IP SLAs
described
67-4
enabling 67-7
response time, measuring with IP SLAs 67-4
restricting access
NTP services
4-8
RADIUS 45-95
TACACS+ 3-15
retransmission number
setting in 802.1X authentication
45-86
retransmission time
changing in 802.1X authentication
45-85
RFC
1157, SNMPv1
61-2
1305, NTP 4-2
1757, RMON 67-2
1901, SNMPv2C 61-2
1902 to 1907, SNMPv2 61-2
2273-2275, SNMPv3 61-2
RFC 5176 Compliance 45-98
RIP
description
1-19
for IPv6 53-5
RIP, introduction 1-19
RMON
default configuration
67-3
displaying status 67-6
enabling alarms and events 67-3
groups supported 67-2
overview 67-1
ROM monitor
boot process and
3-26
CLI 2-7
commands 72-2 to 72-3
debug commands 72-5
entering 72-1
exiting 72-6
overview 72-1
root bridge
configuring
21-9
selecting in MST 21-22
root guard
and MST
21-23
enabling 24-2
overview 24-2
routed packets
ACLs
52-26
route-map (IP) command 39-6, 39-9
route maps
defining
39-6, 39-9
PBR 39-2
router ACLs
description
1-41, 52-3