Contents
41
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL-30933-01
Web-Based Authentication Configuration Task List 47-7
Configuring the Authentication Rule and Interfaces 47-7
Configuring AAA Authentication 47-9
Configuring Switch-to-RADIUS-Server Communication 47-9
Configuring the HTTP Server 47-11
Customizing the Authentication Proxy Web Pages 47-11
Specifying a Redirection URL for Successful Login 47-12
Configuring the Web-Based Authentication Parameters 47-13
Removing Web-Based Authentication Cache Entries 47-14
Displaying Web-Based Authentication Status 47-14
Configuring Port Security 48-1
Port Security Commands 48-2
About Port Security 48-3
Secure MAC Addresses 48-4
Maximum Number of Secure MAC Addresses 48-4
Aging Secure MAC Addresses 48-5
Sticky Addresses on a Port 48-5
Violation Actions 48-6
Invalid Packet Handling 48-7
Configuring Port Security on Access Ports 48-7
Configuring Port Security on Access Ports 48-7
Examples of Port Security on Access Ports 48-10
Example 1: Setting Maximum Number of Secure Addresses 48-11
Example 2: Setting a Violation Mode 48-11
Example 3: Setting the Aging Timer 48-11
Example 4: Setting the Aging Timer Type 48-12
Example 5: Configuring a Secure MAC Address 48-12
Example 6: Configuring Sticky Port Security 48-13
Example 7: Setting a Rate Limit for Bad Packets 48-13
Example 8: Clearing Dynamic Secure MAC Addresses 48-14
Configuring Port Security on PVLAN Ports 48-14
Configuring Port Security on an Isolated Private VLAN Host Port 48-14
Example of Port Security on an Isolated Private VLAN Host Port 48-16
Configuring Port Security on a Private VLAN Promiscuous Port 48-16
Example of Port Security on a Private VLAN Promiscuous Port 48-17
Configuring Port Security on Trunk Ports 48-17
Configuring Trunk Port Security 48-17
Examples of Trunk Port Security 48-19
To Next Page
Loading...
