Cisco Catalyst 4500 Series Administration Guide

5
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL-30933-01
Preface
Chapter 28 Configuring IPv6 Multicast
Listener Discovery Snooping
Describes how to configure IPv6 MLD Snooping.
Chapter 29 Configuring 802.1Q Tunneling,
VLAN Mapping, and Layer 2
Protocol Tunneling
Describes how to configure 802.1Q and Layer 2
protocol Tunneling.
Chapter 30 Configuring CDP Describes how to configure the Cisco Discovery
Protocol (CDP).
Chapter 31 Configuring LLDP, LLDP-MED,
and Location Service
Describes how to configure Link Layer Discovery
Protocol (LLDP).
Chapter 32 Configuring UDLD Describes how to configure the UniDirectional Link
Detection (UDLD) protocol.
Chapter 33 Configuring Unidirectional
Ethernet
Describes how to configure Unidirectional Ethernet
Chapter 34 Configuring Layer 3 Interfaces Describes how to configure interfaces to support
Layer 3 features.
Chapter 35 Configuring Cisco Express
Forwarding
Describes how to configure Cisco Express
Forwarding (CEF) for IP unicast traffic.
Chapter 36 Configuring Unicast Reverse Path
Forwarding
Describes how to configure Unicast Reverse Path
Forwarding.
Chapter 37 Configuring IP Multicast Describes how to configure IP Multicast Multilayer
Switching (MMLS).
Chapter 38 Configuring ANCP Client Describes how to configure ANCP.
Chapter 39 Configuring Bidirection
Forwarding Detection
Describes how to configure Bidirectional
Forwarding Detection
Chapter 40 Configuring Policy-Based
Routing
Describes how to configure policy-based routing.
Chapter 41 Configuring VRF-lite Describes how to configure multiple VPN
routing/forwarding (multi-VRF) instances in
customer edge (CE) devices.
Chapter 42 Configuring Quality of Service Describes how to configure quality of service
(QoS).
Chapter 43 Configuring Voice Interfaces Describes how to configure voice interfaces.
Chapter 44 Configuring Private VLANs Describes how to set up and modify private VLANs.
Chapter 45 Configuring MACsec Encryption Describes how to configure MACsec encryption.
Chapter 46 Configuring 802.1X Port-Based
Authentication
Describes how to conf.igure 802.1X port-based
authentication.
Chapter 47 Configuring the PPPoE
Intermediate Agent
Describes how to configure PPPoE Intermediate
Agent.
Chapter 48 Configuring Web-Based
Authentication
Describes how to configure web-based
authentication.
Chapter 49 Configuring Port Security Describes how to configure port security and trunk
port security.
Chapter 50 Configuring Auto Security Describes how to configure auto security.
Chapter Title Description

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E