Cisco Catalyst 4500 Series Administration Guide

6
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL-30933-01
Preface
Chapter 51 Configuring Control Plane
Policing and Layer 2 Control
Packet QoS
Describes how to protect your Catalyst 4500 series
switch using control plane policing (CoPP).
Chapter 52 Configuring Dynamic ARP
Inspection
Describes how to configure Dynamic ARP
Inspection.
Chapter 53 Configuring DHCP Snooping, IP
Source Guard, and IPSG for Static
Hosts
Describes how to configure DHCP snooping and IP
Source Guard.
Chapter 54 Configuring Network Security
with ACLs
Describes how to configure ACLS, VACLs, and
MACLs.
Chapter 55 Support for IPv6 Describes the support for IPv6 on the switch.
Chapter 56 Port Unicast and Multicast Flood
Blocking
Describes how to configure unicast flood blocking.
Chapter 57 Configuring Storm Control Describes how to configure storm control
suppression.
Chapter 58 Configuring SPAN and RSPAN Describes how to configure the Switched Port
Analyzer (SPAN).
Chapter 59 Configuring Wireshark Describes how to configure Wireshark, the Ethernet
Analyzer on the Catalyst 4500 series switch.
Chapter 60 Configuring Enhanced Object
Tracking
Describres how to configure Enhanced Object
Tracking
Chapter 61 Configuring System Message
Logging
Describes how to configure system message
logging.
Chapter 62 Onboard Failure Logging (OBFL) Describes how to enable OBFL.
Chapter 63 Configuring SNMP Describes how to configure the Simple Network
Management Protocol (SNMP).
Chapter 64 Configuring NetFlow-lite Describes how to configure NetFlow-lite.
Chapter 65 Configuring Flexible NetFlow Describes how to configure Flexible NetFlow,
Chapter 66 Configuring Ethernet OAM and
CFM
Describes how to configure Ethernet OAM and
CFM.
Chapter 67 Configuring Y.1731 (AIS and
RDI)
Describes how to configure Y.1731.
Chapter 68 Configuring Call Home Describes how to configure Call Home.
Chapter 69 Configuring Cisco IOS IP SLA
Operations
Describes how to configure Cisco IOS IP SLA
operations.
Chapter 70 Configuring RMON Describes how to configure Remote Network
Monitoring (RMON).
Chapter 71 Performing Diagnostics Describes various types of diagnostics on the
Catalyst 4500 series switch.
Chapter Title Description

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E