Cisco D9887B User Manual

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
54 78-4043743-01 Rev A
Ancillary Data Packets
This controls the embedding of the Ancillary Data Packets (ADP) into the VANC of
the SDI output.
1 Use the Up and Down buttons to move the cursor to the desired type of
Ancillary Data Packet ("EIA-608CC", "EIA-708CC", "TTX S2031M", "Source ID",
or "SCTE 127", "AFD"), then press the Enter button.
2 Use the Up and Down buttons to choose "Enabled" or "Disabled," then press the
Enter button to save the selection.
3 Use the Up and Down buttons to select "Line" for the ADP and press the Enter
button.
4 Use the Up and Down buttons to change the line number (4 – 15) in which the
ancillary data will be located, then press the Enter button.
Note: Repeat steps 1-4 above to change EIA-708CC, TTX S2031M, Source ID,
SCTE-127 and AFD.
NTSC Waveforms
To enable NTSC items, use the following steps.
1 Use the Up and Down buttons to move the cursor to "Line 21CC," then press the
Enter button.
2 Use the Up and Down buttons to select "Enabled" or "Disabled," then press the
Enter button to save the selection.
Note: Repeat steps 1-2 above to change AMOL and TVG2x.

Cisco D9887B Specifications

General

Brand	Cisco
Model	D9887B
Category	Receiver
Language	English