Comtech EF Data CDM-570AL - Page 294

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Revision 5
Serial-based Remote Product Management 8–28 MN-CDM570A
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction Code
and Qualifier)
Response to
Query
Retrieve next 5
unread Stored
Events
N/A
75 bytes
Query only.
Returns the oldest 5 Stored Events which have not yet been read over the remote
interface.
Reply format: {CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-
body, where Sub-body= ABCddmmyyhhmmss,
A being the fault/clear indicator, where:
F = Fault
C = Clear
I = Info
B being the fault type, where:
1 = Unit
2 = Rx Traffic
3 = Tx Traffic
4 = ODU
5 = Power on/off, or log cleared
C is Fault Code numbers, as in FLT? or Info Code, where:
0 = Power Off
1 = Power On
2 = Log Cleared
3 = Global Config Change
4 = Redundancy Config Change
Notes:
1) If less than 5 events are to be retrieved, the remaining positions are padded with
zeros.
2) If there are no new events, the response is RNE*.
N/A
RNE?
RNE={CR}ABCddm
myyhhmmss{CR}A
BCddmmyyhhmms
s{CR}ABCddmmyy
hhmmss{CR}ABCd
dmmyyhhmmss
{CR}ABCddmmyyh
hmmss (see
Description of
Arguments)
Clear All Stored
Events
CAE=
None
Command only.
This command takes no arguments.
Forces the software to clear the software events log.
CAE=
CAE?
CAE*
CAE#
N/A
N/A
Initialize Events
Pointer
IEP=
None
Command only.
This command takes no arguments.
Resets internal pointer to allow RNE? queries to start at the beginning of the stored
events log.
IEP=
IEP#
N/A
N/A