Comtech EF Data SLM-5650B - 5.2.5 SELECT: Test

SLM-5650B Satellite Modem
Revision 2
Front Panel Operation 5–39 MN-SLM-5650B
Monitor: Stats  Clear-All
Clear All Stored Statistics? No
(E)
Use the arrow keys to select No (to retain) or Yes (to clear all) stored statistics, and
then press [ENT].
Monitor: Stats  Config
Statistics Logging Interval:
10 minutes (E)
Use the  arrow keys to set the Statistics Logging Interval to 10 minutes through 90
minutes (in 10-minute increments), or Disabled, and then press [ENT].
5.2.5 SELECT: Test
TEST: Carrier: Normal Loopback: IF
BERT LampTest (E)
Use the  arrow keys to select Carrier, Loopback, BERT, or LampTest, and then press
[ENT].
Submenu
Function
Carrier
Select Normal, Tx-CW, or Tx-1,0.
Loopback Select Normal or IFℓ
BERT Select Tx, Rx, Pattern, Threshold, Reset, ErrIns, Errs, and BER
LampTest
Select LampTest to perform a diagnostic run on the front panel LEDs and VFD.