SLM-5650B Satellite Modem
Revision 2
Installation 2–7 MN-SLM-5650B
2.3 Connect External Cables
Chapter 3. REAR PANEL CONNECTORS
AND PINOUTS
Connect the cables to the proper locations on the rear panel.
2.4 Configuration
If there is any problem with installation or initial operation, read Appendix A.
TROUBLESHOOTING for possible solutions.
All configurations are implemented locally via the unit’s loaded firmware.
Step Task
1 Read Chapter 5. FRONT PANEL OPERATION before continuing.
Connect the supplied power cable.
3
Set the power switch to ON.
The auto-sensing AC power supply does not require any adjustments.
4 Do a check for the correct transmitter (Tx) and receiver (Rx) output signal levels and spectrums.
Use the front panel keypad and display, or external PC to configure the unit.
To Next Page
Loading...
