Comtech EF Data SLM-5650B - TRANSEC Interface Commands; Queries

SLM-5650B Satellite Modem
Revision 2
Appendix C C–65 MN-SLM-5650B
C.6.10 TRANSEC Interface Commands / Queries
The instruction codes that follow are valid only when the optional TRANSEC Interface Module is installed in the SLM-5650B Satellite
Modem.
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Transec
Ethernet
Interface
Gateway IP
Address
SMG= 15 bytes Command or Query.
Used to set the Gateway IP address for the Transec Management
port in the form aaa.bbb.ccc.ddd, where:
aaa.bbb.ccc.ddd = IP address
Example: SMG = 010.006.030.001
N/A SMG? SMG=
aaa.bbb.ccc.ddd
(see Description of
Arguments)
Transec
Ethernet
Interface
Management IP
Address and
Range
SMI= 18 bytes Command or Query.
Used to set the IP address and network prefix for the Transec
Management port in the form aaa.bbb.ccc.ddd.ee, where:
aaa.bbb.ccc.ddd = IP address
ee = network prefix (0-31)
Example: SMI = 010.006.030.001.24
N/A SMI? SMI=aaa.bbb.ccc
.ddd.ee
(see Description of
Arguments)
Transec
Ethernet
Interface
Management
MAC
N/A 12 bytes Query only.
Returns the Transec’s Ethernet Management MAC
Example: SMM = 0006B003780C
N/A SMM? SMM=
xxxxxxxxxxxx
(see Description of
Arguments)