SLM-5650B Satellite Modem
Revision 2
TRANSEC Module HTTPS Interface 10–10 MN-SLM-5650B
10.4.1.4 Network Parameters
Item Description
Secure Management IP
Allows users to change the IP address of the TRANSEC Module to suit their own
operational environment.
NOTE: If this text box changes, it will be necessary to repeat the process in Section 8.3
using the newly-designated IP address, to regain access to the TRANSEC Web
Interface.
Subnet Bits
Allows users to modify the IP subnet mask of the TRANSEC Module to suit their own
operational environment.
Gateway IP
Allows users to modify the default gateway of the TRANSEC Module to suit their own
operational environment.
NOTE: The IP address entered in the text box must match the subnet of the Secure
Management IP. If it does not then the Gateway IP text box will default to 0.0.0.0.
Click Update Settings to apply changes made to any of these parameters.
10.4.1.5 Crypto Officer Credentials
This section is used to create a TRANSEC Module Crypto Officer Username and Crypto
Officer Password. Note that are each restricted to a minimum of 7 and a maximum of 25
characters, excluding: (ASCII Code 58), < (ASCII Code 60), > (ASCII Code 62), “ (ASCII Code
34), and ~ (ASCII Code 126).
The default for both the Crypto Officer Username and Password is transec.
Item Description
Username
Use this text box to create the desired username.
Use this text box to create the desired password for the username being created.
Confirm Password Use this text box to re-enter the previously entered password.
Once the Username is entered and the Password is confirmed, click Update Credentials to
finalize this update.
To Next Page
Loading...
