Comtech EF Data SLM-5650B - Gigabit Ethernet Interface Commands; Queries

SLM-5650B Satellite Modem
Revision 2
Appendix C C–62 MN-SLM-5650B
C.6.8 Gigabit Ethernet Interface Commands / Queries
The instruction codes that follow are valid only when the optional 10/100/1000Base-T Gigabit Ethernet Interface Module is installed in the
SLM-5650B Satellite Modem.
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to
Query
GBEI Flow
Control
GFC= 1 byte Command or Query.
Used to Enable/Disable Pause Frame flow control on the internal
GBEI Interface, where x is:
0 = Disabled
1 = Enabled
Example: GFC = 0
GFC=
GFC?
GFC*
GFC#
GFC? GFC=x
(see Description of
Arguments)
GBEI WAN
Buffer Length
WBL= 3 bytes Command or Query.
Used to set the WAN Buffer (transmit) Length, where xxx is in
range from 020 mSec to 240 mSec
Example: WBL = 020
WBL=
WBL?
WBL*
WBL#
WBL? WBL=xxx
(see Description of
Arguments)