SLM-5650B Satellite Modem
Revision 2
Front Panel Operation 5–9 MN-SLM-5650B
5.2.3 SELECT: Configure
CONFIG: Tx Rx Mode AUPC Transec
AHO ODU Ref Mask Reset Remote (E)
Use the arrow keys to select a configuration submenu, and then press [ENT].
Submenu Description
Tx (Transmit)
Select to configure the Tx parameters. This menu is not accessible if the modem has been
set to Demod Only.
Rx (Receive) Select to configure the Rx parameters.
Select to configure the modem operating modes.
Select to configure the AUPC parameters.
Select to configure the TRANSEC Module operation.
AHO This feature is a future option and not available at this time.
ODU
Select to enable/disable LNB power, configure the low and high LNB current limits, and to
monitor the LNB voltage and current.
Ref Select to configure the modem reference and to enable/disable BUC and LNB references.
Select to mask selected alarms.
Select to reset the modem to a default status.
Remote
Select to define whether the modem is being controlled locally or remotely as well as the
communication parameters (see IMPORTANT note).
The modem may be monitored over the remote control interface at any time. When in Local
mode, however, configuration parameters may only be changed through the front panel.
To Next Page
Loading...
