Comtech EF Data SLM-5650B - Page 392

SLM-5650B Satellite Modem
Revision 2
Appendix C C–64 MN-SLM-5650B
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Modem IP
Interface
Security Mode
MIS= 1 byte Command or Query.
Used to set the modem IP Interface security level where:
0 = Normal or Low Level Security
1 = High Level Security
Example: MIS = 0
MIS=
MIS?
MIS*
MIS#
MIS? MIS=a
(see Description of
Arguments)
Router IP
Address Mode
RIM= 1 byte Command or Query.
Used to set the NP Card’s IP address mode where:
0 = Single IP Address
1 = Dual IP Address
Example: RIM = 0
RIM=
RIM?
RIM*
RIM#
RIM? RIM=a
(see Description of
Arguments)
Router Ethernet
Interface Traffic
IP Address and
Range
RIP= 18 bytes Command or Query.
Used to set the IP address and network prefix for the
NP Interface Traffic port, in the form aaa.bbb.ccc.ddd.ee, where:
aaa.bbb.ccc.ddd = IP address
ee = network prefix (0-31)
Example: RIP = 010.006.030.001.24
RIP=
RIP?
RIP*
RIP#
RIP? RIP=aaa.bbb.ccc.ddd.ee
(see Description of
Arguments)