SLM-5650B Satellite Modem
Revision 2
TRANSEC Module SSH CLI Operation 11–4 MN-SLM-5650B
If a parameter is rejected for any reason, an error will appear at the top of the page, along with an
explanation that serves to assist the user in the re-entry of information, as per the following
examples:
Any changes made via the CLI should be saved to permanent storage prior to terminating the CLI
session. While changes will remain active so long as the modem remains in operation, take note
also that changes will be lost if, for example, the modem loses power. Modified parameters can
be saved by issuing the Save command “S” from any menu. The user is prompted to confirm that
all changes should be made permanent:
The user is prompted, when attempting to terminate a CLI session via Logout command “L”, to
verify that the session should be ended:
To Next Page
Loading...
