Comtech EF Data SLM-5650B - CHAPTER 3. REAR PANEL CONNECTORS AND PINOUTS; 3.1 Overview; 3.2 IF Connectors; 3.3 Terrestrial Data Connectors

SLM-5650B Satellite Modem
Revision 2
Table of Contents iii MN-SLM-5650B
3.4.2 J8 Alarms Connector (DB-9F) ................................................................................................... 3–9
3.4.3 J9 Auxiliary Connector (HD-15F) .............................................................................................. 3–9
3.4.4 J10 Remote Connector (DB-9F) ............................................................................................. 3–11
3.5 Power/Ground Connectors ...................................................................................................... 3–12
3.5.1 AC Power Connector .............................................................................................................. 3–12
3.5.2 Ground Connector (GND) ....................................................................................................... 3–12
CHAPTER 4. UPDATING FIRMWARE ............................................................................................... 4–1
4.1 Updating Firmware via Internet ................................................................................................. 4–1
4.1.1 About Firmware Files, Naming, Versions, and Archive Formats .............................................. 4–2
4.1.2 Firmware Update using the Comtech EF Data Website ........................................................... 4–3
4.2 Bulk Firmware Update – Ethernet FTP Upload Procedure ........................................................... 4–8
4.3 Network Processor (NP) Interface Module Update Procedure ............................................... 4–9
4.4 TRANSEC Module Update Procedure ..................................................................................... 4–14
CHAPTER 5. FRONT PANEL OPERATION ....................................................................................... 5–1
5.1 Overview ...................................................................................................................................... 5–1
5.1.1 Keypad with Data Entry Array ................................................................................................... 5–2
5.1.2 LED Indicators .......................................................................................................................... 5–3
5.1.3 Vacuum Fluorescent Display (VFD) .......................................................................................... 5–4
5.1.3.1 Screen Saver ................................................................................................................. 5–5
5.1.3.2 Opening Screen ............................................................................................................ 5–5
5.2 SELECT: (Main) Menu ................................................................................................................. 5–6
5.2.1 SELECT (Main) Menu Matrix .................................................................................................... 5–7
5.2.2 Navigating the Menu Screens ................................................................................................... 5–8
5.2.3 SELECT: Configure ................................................................................................................... 5–9
5.2.3.1 CONFIG: Tx ................................................................................................................ 5–10
5.2.3.2 CONFIG: Rx ................................................................................................................ 5–16
5.2.3.3 CONFIG  Mode ........................................................................................................ 5–22
5.2.3.4 CONFIG: AUPC ........................................................................................................... 5–24
5.2.3.5 CONFIG: TRANSEC ................................................................................................... 5–27
5.2.3.6 CONFIG: AHO ............................................................................................................. 5–27
5.2.3.7 CONFIG: ODU ............................................................................................................ 5–27
5.2.3.8 CONFIG: Ref ............................................................................................................... 5–28
5.2.3.9 CONFIG: Mask ............................................................................................................ 5–28
5.2.3.10 CONFIG: Reset ........................................................................................................... 5–28
5.2.3.11 CONFIG: Remote ........................................................................................................ 5–29
5.2.4 SELECT: Monitor .................................................................................................................... 5–34
5.2.4.1 Monitor: Alarms ........................................................................................................... 5–34
5.2.4.2 Monitor: Event-Log ...................................................................................................... 5–37
5.2.4.3 Monitor: Rx-Params .................................................................................................... 5–38
5.2.4.4 Monitor: CnC (DoubleTalk
®
Carrier-in-Carrier
®
) .......................................................... 5–38
5.2.4.5 Monitor: Stats (Statistics) ............................................................................................. 5–38
5.2.5 SELECT: Test .......................................................................................................................... 5–39
5.2.5.1 Test: BERT .................................................................................................................. 5–40
5.2.5.2 Test: LampTest ............................................................................................................ 5–40
5.2.6 SELECT: Save/Load ............................................................................................................... 5–41
5.2.7 SELECT: Utility ........................................................................................................................ 5–42
5.2.7.1 Utility: RT-Clk ............................................................................................................... 5–42
5.2.7.2 Utility: RefAdjust .......................................................................................................... 5–42
5.2.7.3 Utility: ID ...................................................................................................................... 5–42
5.2.7.4 Utility: Display .............................................................................................................. 5–42
5.2.7.5 Utility: Temp ................................................................................................................. 5–43
5.2.7.6 Utility: AGC .................................................................................................................. 5–43
5.2.7.7 Utility: Alarm ................................................................................................................ 5–43