7-4 Magellan
TM
8500Xt Scanner
What Is Programming Mode?
Programming Mode is a state in which the scanner must be placed in
order to accept commands via programming barcode labels. When pro-
gramming using the barcode labels in this manual, the scanner is typically
placed in P
rogramming Mode by scanning the SWITCH label.
While in the Programming Mode, the scan
ner only recognizes the special
programming barcodes contained in this programming guide. See
Appen-
dix A for information about scanner indications while in the Programming
Mode.
Entering and Exiting Programming Mode.
Use the barcode label below to enter and exit (‘switch” into and out of)
Programming Mode.
SWITCH LABEL
To Next Page
Loading...
