Product Reference Guide 7-23
Good Read Beep Frequency
Adjusts the scanner’s good read beep to sound at low, medium, or high fre-
quency (controls the beeper’s pitch/tone).
• Low = 660 Hz
• Medium = 860 Hz
• High = 1050 Hz
To set the Good Read Beep Frequency:
1. Scan the SWITCH barcode.
2. Scan your selection from the three barcodes below. You’ll need to
co
ver any unused barcodes on this and the facing page to ensure
that the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scan
ning the SWITCH
barcode.
GOOD READ BEEP FREQUENCY = LOW
To Next Page
Loading...
