Datalogic Magellan 8500Xt User Manual

Product Reference Guide 7-33
Scale Enforced Zero Return
This feature enables/disables the enforced zero return of the scale. Three
settings are available for this feature:
•Disable
• Scale Must Return to Zero Weight Within Four Minutes — Scale
will r
equire re-zeroing if a non-zero weight is left on for more
than 4 minutes
• Scale Must Return to Zero Weight Between Weight Requests —
R
e-zeroing required if weight doesn't return to zero between
weight requests from the POS, plus scale will require re-zeroing if
a non-zero weight is left on for more than 4 minutes.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan your selection from the barcodes belo
w. You’ll need to cover
any unused barcodes on this and the facing page to ensure that
the scanner reads only the barcode you intend to scan. The strat-
egy is to select the lowest possible filter level needed that allows
normal scale operation.
3. Complete the programming sequence by scan
ning the SWITCH
barcode.
SCALE ENFORCED ZERO RETURN = DISABLE

Datalogic Magellan 8500Xt Specifications

General

Type	Built-in bar code reader
Sensor type	-
Read rate (max)	6400 reads/s
Yaw reading angle	0 - 360 °
Linear (1D) barcodes supported	GS1-128 (UCC/EAN-128)
2D (matrix & stacked) barcodes supported	Not supported
Standard interfaces	RS-232
Connectivity technology	Wired
Input voltage	100 - 250 V
Input frequency	50 Hz
Power source type	AC
Power consumption (typical)	9 W
Product color	Grey, Silver
Sustainability certificates	RoHS
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Depth	127 mm
Width	292 mm
Height	178 mm
Weight	- g