Product Reference Guide 7-9
LED and Beeper Indicators
The scanner provides a set of indicators that verify/announce the various
scanner functions.
If You Make a Mistake...
If, during a programming session, you find that you are unsure of the
scanner’s settings or wish to reset the scanner’s configuration, use the
Return to Factory Settings label below to return the scanner’s configura-
tion to the factory settings. Scanning this label will also reset any changes
made
during previous programming sessions.
Return to Factory Settings
Scan this barcode to return the scanner to the default settings configured
at the factory for the currently active interface. This barcode is typically
used to return the scanner to a “known” operating state when the present
programming status is not known, faulty, or suspect
CAUTION
Use this barcode with caution, since it
will reset ALL features that may have
been programmed since the scanner’s installation.
.
NOTE
DO NOT scan the SWITCH barcode before and after scanning this bar
code.
RETURN TO FACTORY SETTINGS
To Next Page
Loading...
