Product Reference Guide 7-95
RS-232 Number of Stop Bits
Specifies number of stop bits required for sending and receiving data.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan the barcode below representing th
e desired Stop Bit setting.
You’ll need to cover any unused barcodes on this and the facing
page to ensure that the scanner reads only the barcode you intend
to scan.
3. Complete the programming sequence by scan
ning the SWITCH
barcode.
RS-232 NUMBER OF STOP BITS = 1
RS-232 NUMBER OF STOP BITS = 2
To Next Page
Loading...
