Product Reference Guide 7-15
Motor Timeout
The Motor Timeout feature sets the time for automatically switching the
motor off when the scanner is not in use.
NOTE
Laser safety requires that the laser switch off bef
ore the motor. If you set the
motor timeout shorter than the laser timeout, the motor and the laser will
both shut off when the motor timeout expires.
To set the Motor Timeout:
1. Scan the SWITCH barcode.
2. Scan your selection from the barcodes belo
w. You’ll need to cover
any unused barcodes on this and the facing page to ensure that
the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scan
ning the SWITCH
barcode.
MOTOR TIMEOUT = 5 MINUTES
To Next Page
Loading...
