Product Reference Guide 7-103
RS-232 Host Echo Quiet Interval
This setting specifies the time interval of RS-232 channel inactivity which
must transpire before the scanner will break the host echo loop to transmit
the barcode data that has just been scanned to the host.
• 0 - 100 = Time in 10-millisecond increments.
To set the Host Echo Quiet Interval:
1. Scan the SWITCH barcode.
2. Scan the barcode below, SET RS-232 HOST ECHO QUIET
INTERVAL. You’ll need to cover any unused barcodes on this and
the facing page to ensure that the scanner reads only the barcode
y
ou intend to scan.
3. Scan the appropriate digits from the keypad in
Appendix C that
represent the desired timeout. The selectable range is 0-100,
which
is the timeout in 10-millisecond increments. Pad all single
and double digit numbers with leading zeroes to yield a three-
digit entry (000-100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the
appr
opriate amount of digits have been scanned.
SET RS-232 HOST ECHO QUIET INTERVAL
To Next Page
Loading...
