Product Reference Guide 7-51
EAS Deactivation Duration — Coupled
Specifies the amount of time EAS deactivation is operative once the func-
tion has been initiated following a barcode read.
NOTE
This setting pertains only to units configured for EAS Coupled Mode. Refer-
ence the EAS Mode description for more information about
Coupled and
Decoupled EAS operation.
To set the EAS Deactivation Duration — Coupled:
1. Scan the SWITCH barcode.
2. Scan the barcode,
SET EAS DEACTIVATION DURATION — COUPLED
below. You’ll need to cover any unused barcodes on this and the fac-
ing page to ensure that the scanner reads only the barcode you
intend to scan.
3. Scan the appropriate digits from the keypad in
Appendix C that rep-
resent the desired duration. The selectable range is 1-255, which is
the duration
in 10-millisecond increments. Pad all single and double
digit numbers with leading zeroes to yield a three-digit entry (001-
255).
Examples:
005 = 50ms
040 = 400ms
250 = 2,500ms (2.5 seconds)
4. The scanner will automatically exit Programming Mode when the
appr
opriate amount of digits have been scanned.
SET EAS DEACTIVATION DURATION — COUPLED
To Next Page
Loading...
