Product Reference Guide 7-277
Standard 2 of 5 Stitching
Enables/disables stitching for Standard 2 of 5 labels. When parts of a Stan-
dard 2 of 5 barcode are presented to the scanner with this feature enabled,
the barcode par
ts will be assembled by the scanner’s software, and the data
will be decoded if all barcode proofing requirements are met.
NOTE
This applies when Standard 2 of 5 Length Control is set to fixed-
length decoding.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan your selection from the barcodes below. You’ll need to cover
any unused bar
codes on this and the facing page to ensure that the
scanner reads only the barcode you intend to scan.
Complete the programming sequence b
y scanning the SWITCH barcode.
STANDARD 2 OF 5 STITCHING = DISABLE
STANDARD 2 OF 5 STITCHING = ENABLE
To Next Page
Loading...
