Product Reference Guide 7-11
General Scanner and Scale Features
Double Read Timeout
The Double Read Timeout feature sets a time limit that determines how
much time must pass before reading the same label again (e.g. two identi-
cal items in succession).
To set the Double Read Timeout:
1. Scan the SWITCH barcode.
2. Scan your selection from the barcodes belo
w. You’ll need to cover
any unused barcodes on this and the facing page to ensure that
the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scan
ning the SWITCH
barcode.
NOTE
If the incidence of multiple reads is not ac
ceptable, increase the Double Read
Timeout setting to a higher value.
DOUBLE READ TIMEOUT = 400ms
DOUBLE READ TIMEOUT = 600ms
To Next Page
Loading...
