7-10 Magellan
TM
8500Xt Scanner
Test Mode
Use this feature to place the scanner into a testing, or “demo” mode. This
special mode disables the scanner interface, meaning that barcode data is
not sent out to the host via the scanner interface. This allows the barcode
to be scanned continuously without requiring a response from the POS
terminal.
To return the scanner to normal function, scan the TEST MODE = DIS-
ABLE barcode below.
NOTE
DO NOT scan the SWITCH barcode before and after scanning the bar
codes on
this page.
Scanning the TEST MODE = DISABLE barcode sets the Double Read
Timeout to 600ms.
TEST MODE = DISABLE
TEST MODE = ENABLE
To Next Page
Loading...
