Datalogic Magellan 8500Xt

7-94 Magellan
TM
8500Xt Scanner
RS-232 Number of Data Bits
Specifies number of data bits required for sending and receiving data.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan the barcode below representing the desired Data Bit setting.
Y
ou’ll need to cover any unused barcodes on this and the facing
page to ensure that the scanner reads only the barcode you intend
to scan.
3. Complete the programming seque
nce by scanning the SWITCH
barcode.
RS-232 NUMBER OF DATA BITS = 7
RS-232 NUMBER OF DATA BITS = 8