7-204 Magellan
TM
8500Xt Scanner
Code 39 Start Stop Character Transmission
Enables/disables transmission of Code 39 start and stop characters.
NOTE
This item is ignored when the advanced f
eature, Full Label Edit, is enabled.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan either the enable or disable barcode below. You’ll need to
co
ver any unused barcodes on this and the facing page to ensure
that the scanner reads only the barcode you intend to scan.
3. Complete the programming seque
nce by scanning the SWITCH
barcode.
CODE 39 START STOP CHARACTER TRANSMISSION = DISABLE
CODE 39 START STOP CHARACTER TRANSMISSION = ENABLE
To Next Page
Loading...
