Datalogic Magellan 8500Xt

7-26 Magellan
TM
8500Xt Scanner
Good Read Beep Volume
Selects the beeper volume upon a good read beep. There are four select-
able volumes, with each volume increment adding approximately five
decibels to th
e previous level:
•0 = Lowest Volume
• 1 = Low Volume
•2 = Medium Volume
•3 = High Volume
To set the Good Read Beep Volume:
1. Scan the SWITCH barcode.
2. Scan your selected volume barcode from this or the following
pages. Y
ou’ll need to cover any unused barcodes on this and the
facing page to ensure that the scanner reads only the barcode you
intend to scan.
3. Complete the programming seque
nce by scanning the SWITCH
barcode.
GOOD READ BEEP VOLUME = LOWEST