7-22 Magellan
TM
8500Xt Scanner
Good Read Beep Control
This feature enables/disables scanner beep upon successfully decoding of a
label.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan your selection from the two bar
codes below. You’ll need to
cover any unused barcodes on this and the facing page to ensure
that the scanner reads only the barcode you intend to scan.
3. Complete the programming seque
nce by scanning the SWITCH
barcode.
GOOD READ BEEP = DISABLE
GOOD READ BEEP = ENABLE
To Next Page
Loading...
