Product Reference Guide 7-145
UPC-E Number System Character Transmission
Enables/disables transmission of a UPC-E number system character.
NOTE
This item is ignored when the
advanced feature, Full Label Edit, is enabled.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan either the enable or disable barcode below. You’ll need to
co
ver any unused barcodes on this and the facing page to ensure
that the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scan
ning the SWITCH
barcode.
UPC-E NUMBER SYSTEM CHARACTER TRANSMISSION = DISABLE
UPC-E NUMBER SYSTEM CHARACTER TRANSMISSION = ENABLE
To Next Page
Loading...
