7-272 Magellan
TM
8500Xt Scanner
Standard 2 of 5 AIM ID
This feature enables/disables transmission of the Standard 2 of 5 AIM
symbology identifier.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan your selection from the barcodes below. You’ll need to cover
any unused bar
codes on this and the facing page to ensure that the
scanner reads only the barcode you intend to scan.
3. Complete the programming sequence b
y scanning the SWITCH
barcode.
STANDARD 2 of 5 AIM ID = DISABLE
STANDARD 2 of 5 AIM ID = ENABLE
To Next Page
Loading...
