Product Reference Guide 7-137
UPC-A Check Character Transmission
Enables/disables transmission of a UPC-A check character.
NOTE
This item is ignored when the advanced f
eature, Full Label Edit, is enabled.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan either the enable or disable barcode below. You’ll need to
co
ver any unused barcodes on this and the facing page to ensure
that the scanner reads only the barcode you intend to scan.
3. Complete the programming sequence by scan
ning the SWITCH
barcode.
UPC-A CHECK CHARACTER TRANSMISSION = DISABLE
UPC-A CHECK CHARACTER TRANSMISSION = ENABLE
To Next Page
Loading...
