Product Reference Guide 7-49
Manual EAS Deactivation Push Button — continued
Remember to cover any unused barcodes on this and the facing page to
ensure that the scanner reads only the barcode you intend to scan.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan your selection from the barcodes below. You’ll need to cover
any unused bar
codes on this and the facing page to ensure that the
scanner reads only the barcode you intend to scan.
3. Complete the programming sequence b
y scanning the SWITCH
barcode.
MANUAL EAS DEACTIVATON PUSH BUTTON = DISABLE
MANUAL EAS DEACTIVATON PUSH BUTTON = ENABLE ALWAYS
To Next Page
Loading...
