DURKOPP ADLER 755 A

Programming
Service Instructions 755 A/756 A - 00.0 - 02/2019 301
To create a seam program:
1. Press the desired button.
2. Enter the desired value using the numeric keypad.
3. Confirm with OK.
Securement seam end left/right needle
• Stitch condensing OR
• Single tack OR
• Double tack
Flap left
OR
Flap right
Set correction value of positioning point at seam beginning  p. 305
• -100 mm - 100 mm
Set correction value of positioning point in the middle of the
seam  p. 305
• -100 mm - 100 mm
Set correction value of positioning point at seam end  p. 305
• -100 mm - 100 mm
• The correction value will be adopted when you switch
positioning points
• The basic values for the positioning points seam beginning/
middle of the seam/seam end are set in the Global
parameters ( p. 358)
Set stitch length main seam
• 1.5 mm - 4.5 mm
Set flap scan  p. 306
• Fixed seam length
• 1 light barrier
• Automatic flap scan left
Reset seam program
Symbols Meaning