Programming
358 Service Instructions 755 A/756 A - 00.0 - 02/2019
Symbol Description
Set positioning point seam begin./center/end
• Set positioning point seam begin. (100 mm - 300 mm)
• Set positioning point seam center (100 mm - 300 mm)
• Set positioning point seam end (100 mm - 300 mm)
Adjust transport clamp p. 360
Set needle thread-clamp/-catcher/-tension p. 361
Zipper cutter
• Set cutting duration (0 ms - 1000 ms)
Adjust corner knife
• Set cutting duration (0 ms - 1000 ms)
set maximum hook thread counter
• only visible in global parameters if hook thread monitor is
deactivated in the machine configuration p. 349
• Maximum hook thread counter On/Off
• Use the numeric keypad to enter the length of the hook thread
in meters which will fit on the bobbin
Needle thread monitor On/Off
Transport clamp quick adjustment
• only visible in global parameters if transport clamp adjustment
is set to AUTOMATIC in the machine configuration
• without bypass
• bypass left
• bypass right
• bypass left and right
To Next Page
Loading...
