EPSON EPL-N4000/EPL-N4000+ Chapter 3 Troubleshooting
Rev.B 98
Turn Paper LC1
∼
3 (Error)
Explanation
This error appears when A4, LT or B5 size paper is set
portrait(short ed
e first).
Remedy
Reset the paper landscape(lon
e first). The error is
cancelled after closin
the cassette.
Can’ Print Duplex (Error)
Explanation
This error appears when duplex printin
is not available
accordin
to its rules.
Remedy
Pressin
“Continue” switch will resume printin
, but it will be
one-side printin
. If “Auto Error Cancel” is On on the device
error, one-side printin
will be resumed after a while. If the error
cause is related to the settin
of the paper feed device, duplex
printin
ed.
Paper Set ssss ttt (Error)
Explanation
This error appears when the paper size in the selected paper
feedin
device does not match with the paper size which is
about to be printed out.
Invalid Option (Error)
Explanation
Finisher or HDD, which can not be used for this printer, is
installed in the printer.
Remedy
Turn off the power and remove the correspondin
optional
device. In case of the options which are supported for this
printer, perform the version up of the firmware.
Collate was disabled (Warnin
)
Explanation
Due to the lack of memory, all necessary data becomes unable
to be stored, as a result, appointed job printin
can not be done.
Or, copy number which exceeds the maximum bin number is
requested.
Only 1 copy from the fist pa
e is printed.
Check Paper Type (Warnin
)
Explanation
When paper feedin
device and paper type are selected
automatically, this error appears in case that there is no device,
which support both that paper size and paper type, or paper size
matches but not paper type. If paper type and paper size
matches but there is no paper in the device, this becomes Paper
Out error, and this error does not appear.
Outbin Select Error (Warnin
to the rules of paper exit, the appointed paper exit
becomes invalid, and paper is ejected to the other paper exit.
To Next Page
Loading...
