Epson EPL-N4000 - Page 261

EPSON EPL-N4000/EPL-N4000+ Chapter 7 Appendix
Rev.B 247
Figure 7-19. Other Clutch and Sensor, Offset Mother, Exit Gate
Solenoid
↔
MCU PWB
Table 7-17. Signal Name
Signal Name Description
CL$FEED1 Controls Tra
y
1 paper feed. Hi
g
h=No feed. Low=Feed
CL$RGATE Controls Re
g
istration Clutch. Hi
g
h=Clutch off.
Low=Clutch on
STS#FSR Fuser Heat Roll temperature. Analo
g
si
g
nal.
SNR#FEXIT Monitors paper leavin
g
the Fuser. Hi
g
h=Paper present.
Low=Paper not present
SNR#FUT Monitors paper arrivin
g
at the Face Up output tra
y
.
Hi
g
h=Paper not present. Low=Pape present
SOL$GATE Controls Gate Solenoid. Hi
g
h=Face Down output.
Low=Face Up output.
CL$ICCW Controls Inverter CCW Clutch. Hi
g
h=Off. Low=On
CLS$ICW Controls Inverter CW Clutch. Hi
g
h=Off. Low=On
OMOT$FWD Controls forward motion of the Offset Motor. Hi
g
h=On.
Low=Off
OMOT$REV Controls reverse motion of the Offset motor. Hi
g
h=On.
Low=Off
SNR#STK Monitors the Full Stack Sensor. Hi
g
h=Tra
y
full.
Low=Tra
y
not full